Hello again
today i will show you how to build your first burning laser

you need:
16x (or higher) dvd burner from your old pc
aixiz laser housing(from mfgcn.com )
soldering iron(or gun)
time from your life

instructions:
remove all the screws and take parts of case
you will find two laser diodes
the one with 4 pins is an powerfull infrared burning diode BUT very dangerous!
the other is our target,the laser diode with 3 pins
remove it very carefully
if you break it you will need a new DVD burner..
now take the driver
on the one side you will see possitive and negative terminals(+-)
on the other you will see the follow terminals (GD & LD)
the GD is the negative and the LD is the possitive
connect ceruffy wires to the -&+ and take the axiz module,remove the lens and push slowly the diode on it..
then connect the possitive pin of diode to LD and the negative to GD
close the case and connect it to 6 volts(4 AA batteries works perfect)

And here we go
your new laser pointer eaily poping balloons and melts black plastic
also you can use it for burn matches or ciggarets
you can pyramatic with other things BUT protect your eyes!
laser 50mW+ can break eyes

BE CAREFULL!
im not responsible for any damage in your system or your eyes
check out my youtube channel for other laser vids

mode?

Good evening and welcome to my site
only created for you so you can see any videos and instruction to make your own DIY
check out my youtube channel for more instructions
http://www.youtube.com/user/modethe1
enjoy :)